Owner`s manual

OPERATION
52
3434
ACTIVE
SYNC
STATION SELECT
THROTTLE
ONLY
To disengage, move one or both control handles until they are more than 5° apart, reduce engine speed
below 900 RPM, or increase engine speed beyond 95%.
Stopping The Engine
IMPORTANT: Turning key to the "START" position while the engine is running will result in engine shut
down, while leaving the DTS system active. This will allow the use of the power trim/tilt from the remote
control handle.
Reduce engine speed and shift outboard to neutral position. Turn ignition key to "OFF" position.
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
3482
Remote Control Adjustments
5176
+
-
a
b
a
b
ob01170
+
-
a - Detent tension adjustment b - Control handle friction adjustment screw
1. Remove cover to gain access to screws.
2. Detent tension adjustment ‑ The detent screw can be adjusted to increase or decrease the effort
needed to move the control handle into or out of detent position.
3. Control handle friction adjustment ‑ The friction adjustment screw can be adjusted to increase or
decrease the overall effort to move the control handle. This will help prevent unwanted motion of
the handle in rough water.