Owner`s manual

MAINTENANCE
68
Tube Ref No. Description Where Used Part No.
81
Anti-Seize
Compound
Spark plug threads 92-881091K1
7. Clean area of spark plug seat.
8. Before installing spark plugs, clean off any dirt on the spark plug seats. Install plugs finger tight,
and then tighten 1/4 turn or torque to specifications.
Description Nm lb. in. lb. ft.
Spark plug 27 20
9. Push pencil coils into place over the spark plugs using a twisting motion.
10. Secure coils with retained bolts. Torque to specifications.
Description Nm lb. in. lb. ft.
Bolts 8 71
11. Connect the six wiring harness connectors to pencil coil connections.
a
b
c
3658
a - Wiring harness connector
b - Pencil coil
c - Bolt
12. Reinstall rear and top cowls.
Fuses
The electrical wiring circuits on the outboard are protected from overload by fuses in the wiring. If a fuse
is blown, try to locate and correct the cause of the overload. If the cause is not found, the fuse may blow
again.
1. Remove top cowl. Locate fuse holder on starboard side of engine.
ob01516