Service manual

90-898303
4-12
Prime the oil injection pump as follows:
1) Fill the engine fuel system with fuel. Connect fuel hose and squeeze
primer bulb until it fells firm.
2) Turn the ignition key switch to the “ON” position.
3) Within the first 10 seconds after the key switch has been turned on, move
the remote control handle from neutral into forward gear 3 to 5 times. This
will automatically start the priming process.
NOTE: It may take a few minutes for the pump to complete the priming
process.
Notes
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________