Specifications

STORAGE
90-860168040 JANUARY 2004 Page 97
NOTE: It may be necessary to lift or bend hoses to allow water to drain completely.
4. Remove and lower the hose from the water inlet to power steering cooler, if equipped,
or water inlet to heat exchanger.
75488
a
b
a-Power steering cooler, if equipped
b-Water inlet to heat exchanger hose
5. Make sure gear housing water vent and drain holes, speedometer pitot hole and trim
tab cavity vent and drain holes are open and unobstructed.
71216
d
b
a
c
a-Vent holes
b-Anode cavity drain holes
c-Drain hole
d-Speedometer pitot hole
6. Crank engine over, slightly with starter motor to purge any water trapped in seawater
pickup pump. Do not allow engine to start.