Specifications

MAINTENANCE
Page 78 90-860168040 JANUARY 2004
0156.01
INSTALLATION
76910
a
f
b
c
d
e
g
a-Propeller shaft
b-Thrust hub
c-Flo-Torque II drive hub
d-Propeller
e-Drive sleeve
f-Locking tab washer
g-Propeller nut
IMPORTANT: If reusing tab washer, carefully inspect tabs for cracks or other damage.
Replace tab washer if condition is questionable.
1. Apply a liberal coat of one of the following lubricants to the propeller shaft.
Description
Where used Part number
Anti-Corrosion Grease 92-802867A1
Special Lubricant 101
Propeller shaft
92-802865A1
2-4-C with Teflon 92-802859A1
2. Slide thrust hub onto propeller shaft, with stepped side toward propeller hub.
3. Install Flo-Torque II Drive Hub into propeller.
NOTE: The drive sleeve is tapered and will slide fully into the propeller as the nut is tightened
and properly torqued.
4. Align splines and place propeller on propeller shaft.
5. Install drive sleeve and locking tab washer.
6. Install and torque the propeller nut.
Description
Nm lb-in. lb-ft
Propeller nut
1
75 55
1
The propeller torque stated is the minimum torque value.
7. Bend three tabs on the tab washer down into the grooves in spline washer. After the first
use, bend the three tabs straight and retorque the propeller nut. Bend tabs back down
into spline washer. Check propeller at least after 20 hours of operation. Do not operate
with loose propeller.