Specifications

47
CB828
Checking Fluid Levels (Continued)
1
77631
2A
70979
CA888
CHECKING DRIVE UNIT OIL
NOTE: Oil level will fluctuate during operation. Oil level should be checked with cold engine before starting.
1 Check gear lube monitor oil level. Keep oil level at or near FULL line. If any water is visible at the bottom of
monitor or appears at the oil fill/drain plug and/or if oil appears discolored, contact your Authorized Mercury
MerCruiser Dealer immediately. Both conditions may indicate a water leak somewhere in the drive unit.
IMPORTANT: If more than 2 fl. oz. (59ml) of Quicksilver High Performance Gear Lube is required to fill
monitor, a seal may be leaking. Damage to drive unit may occur due to lack of lubrication. Contact your
Authorized Mercury MerCruiser Dealer for service.
CA942
CHECKING POWER TRIM PUMP FLUID
Place drive unit in full down/in position.
2 Remove fill cap from reservoir and observe oil level. Level must be up to, but not over bottom of filler neck.
Add Quicksilver Power Trim and Steering Fluid or SAE 10W-30 motor oil, if required, to bring level to bottom
of filler neck. Replace cap.
A Check that cap plug has been removed from filler neck and discarded.
B Fill cap is vented.
INDEX