Specifications

CB829

Lubrication (Continued)

70558

71569

CA525

Drive Unit and Transom Assembly

1 Lubricate gimbal bearing by applying approximately 8-10 pumps of grease from a typical hand-operated

grease gun using Quicksilver U-Joint and Gimbal Bearing Grease.

2 For propeller shaft lubrication, see PROPELLER.

CB809

Engine Coupler

3 Lubricate engine coupler splines through grease fittings on coupler by applying approximately 8-10 pumps

of grease from a typical hand-operated grease gun using Quicksilver Engine Coupler Spline Grease. If boat

is operated at idle for prolonged periods of time, coupler should be lubricated every 50 hours.

NOTE: Bravo Models - Your engine is equipped with a sealed engine coupler. The sealed coupler and shaft

splines can be lubricated without removing the drive unit.

NOTE: Bravo Models - The crosses and bearings on the drive U-joint will need to be lubricated through the

grease fittings. Apply Quicksilver U-joint and Gimbal Bearing Grease from a typical hand-operated grease gun

until a small amount of grease begins to push out. The sterndrive unit must be removed to grease these fittings.

INDEX