Specifications

57
CA818
INSTALLATION
4
5
6
7
9
70561
BRAVO
ONE
BRAVO
TWO
76910
8B
8A
9
7
5
IMPORTANT: If reusing tab washer, carefully inspect tabs for cracks or other damage. Replace tab
washer if condition is questionable.
4 Apply a liberal coat of one of the following Quicksilver lubricants to propeller shaft: Anti-Corrosion Grease,
Special Lubricant 101 or 2-4-C Marine Lubricant with Teflon.
5 Slide thrust hub into propeller hub, with stepped side toward propeller hub.
6 Bravo One: Install Flo-Torque II Drive Hub into propeller.
NOTE: The drive sleeve is tapered and will slide fully into the propeller as the nut is tightened and properly
torqued.
7 Align splines and place propeller on propeller shaft.
8 Install final attaching hardware.
A Bravo One: Install drive sleeve adapter and locking tab washer.
B Bravo Two: Install spline washer and tab washer.
9 Install propeller nut. Tighten nut securely. A minimum of 55 lb-ft (75 Nm) torque is required. Bend three tabs
on tab washer down into grooves in spline washer. After first use, bend the three tabs straight, retighten
propeller nut to minimum 55 lb-ft torque (75 Nm). Bend tabs back down into spline washer. Check propeller
at least every 20 hours of operation. Do not operate with loose propeller.
INDEX