Service manual

BRAVO ONE GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3B-44 90-863160 MAY 2000
31. Install gear housing to drive shaft housing. Torque fasteners to 35 lb-ft (47 Nm).
a
b
76879
a-Nuts And Washers (3 Each Side)
b-Bolt (Located In Anodic Plate Cavity)
32. Install anodic plate. Torque bolt to 20 lb-ft (27 Nm).
a
b
76880
a-Bolt
b-Anodic Plate
33. Install rubber plug.
22093
a
a-Rubber Plug
34. Reinstall sterndrive unit. Refer to SECTION 2A - Removal, Installation and Adjustments.
35. Fill sterndrive unit with Gear Lube. Refer to SECTION 1B - Maintenance.
INDEX