Service manual

SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 4B-33
4. Position grounding clips on bellows. Use bellows P/N 18654, only. Do not substitute
earlier model bellows.
22079
a
b
b
c
a-Apply Bellows Adhesive
b-Grounding Clips
c- Part Number
WARNING
Read and follow package label directions when using bellows adhesive.
5. Apply bellows adhesive to exhaust bellows mounting surface. Allow to dry until adhesive
is no longer tacky (approximately 10 minutes) before installing.
22450
a
a-Mounting Surface
6. Install exhaust bellows on gimbal housing flange.
7. Position hose clamp as shown. Torque to 35 lb-in. (4 Nm).
76660
a
b
a-Exhaust Bellows
b-Hose Clamp
INDEX