Service manual

ACCESSORIES - ALL MODELS
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 8A-9
Reassembly
1. Press the new oil seals into the end plate/housing until the seals bottom out. The seal
lips face in the direction shown.
50452
a
a-New Oil Seals
2. Wrap the diameter of the shaft (area “a,”) with masking tape to protect the seal lips.
3. Generously lubricate the shaft with 2-4-C Marine Lubricant with Teflon.
4. Lubricate the seal lips with 2-4-C Marine Lubricant with Teflon, then slide the end plate
housing onto the shaft. You may need to tap the housing into the valve guide bracket,
to seat it fully.
5. Remove the masking tape from the shaft end.
a. Install thru-bolts, flat washers and nuts. Tighten the bolts by hand.
b. Torque the end plate bolts and copper sealing washers to 132 lb-in. (15 Nm).
c. Torque the thru-bolts to 72 lb-in. (8 Nm).
50339
50453
a
b
c
d
a-Put Masking Tape Over Shaft Diameter (Area “a”)
b-End Plate Bolts
c-Thru-bolts
d-Drive Shaft
6. Press a new seal, lip facing out, into the seal tube, so that the seal is flush with the end
of the tube.
INDEX