Automobile Parts User Manual

D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS

Page 16 of 90

76010

D7.3L D-Tronic Shown - All Similar

a-Engine Harness Connector

b-Extension Harness Connector (From Instruments)

c-Electrical Bracket

TACHOMETER SPECIAL INFORMATION

IMPORTANT: If using a tachometer from another manufacturer,

do not use the mag-

netic tachometer pickup

(or related wiring) mounted on the flywheel housing.

If using the Quicksilver Tachometer provided with the engine package, the appropriate set-

ting of the switch located on the back of the tachometer is given in the following chart.

Tachometer Switch Setting

Model

Switch Position

(Teeth Count on Flywheel)

D7.3L D-Tronic and D7.3L D-Tronic LD 4 (155)

Power Trim Control

Any of the Quicksilver panel or in-handle type trim controls (that are specified for use with

MerCruiser sterndrives) can be used with this Power Trim system. Install trim control in ac-

cordance with instructions that accompany it.

Power Trim Pump Location

Select an appropriate mounting location for the trim pump that meets the following require-

ments:

• Within limits of black and gray hydraulic hoses (coming from gimbal housing assembly).

• Close to the battery so that trim pump battery leads can be connected.

• Allow easy access to trim pump oil fill and vent locations.

• Area where pump will not be exposed to water.

• Trim pump must be mounted so that when steering wheel is turned in either direction

(right or left), the power steering booster cylinder does not come in contact with trim

pump.