Automobile Parts User Manual

D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 30 of 90
Inner Transom Plate
1. Insert wires, hoses and shift cable through appropriate openings in inner transom plate.
2. Position gimbal housing on transom and hold in place.
NOTE: When tightening transom assembly fasteners in the following step, start in the center
and, using a circular pattern, move outward. Tighten in small increments and go around the
pattern several times until the proper torque is achieved.
IMPORTANT: Steering lever continuity circuit wire must be positioned as shown to
avoid stressing wire when steering lever moves.
72043
71626
71628
70005
71629
c
a
a
a
b
d
a-Locknuts and Flat Washers (8)
b-Bolt
c-Steering Lever Continuity Wire
d-Transom Plate Continuity Wire
3. Secure transom assembly with hardware as shown. Torque to 20-25 Ib-ft (27-34 Nm).