Owner`s manual

COLD WEATHER OR EXTENDED STORAGE
104
19.Make sure the drainage passage near the anode in the
anti‑cavitation plate is open and unobstructed.
12893
a
a - Anti‑cavitation plate anode drain hole
20.The drive unit should be stored in the full down position.
NOTICE
The universal joint bellows may develop a set when stored in a
raised or up position, causing the bellows to fail when returned
to service and allowing water to enter the boat. Store the
sterndrive in the full down position.
21.Perform all yearly checks, inspections, lubrication and fluid
changes as outlined in the Maintenance Chart of this manual.
Cooling System Draining Instructions
NOTICE
Avoid cooling system and engine damage. Water trapped in the
seawater section of the cooling system can cause corrosion
damage, freeze damage, or both. Ensure the seawater section
of the cooling system is drained immediately after operation, or
before any length of storage in cold weather, if the possibility of
freezing temperatures exists. If the boat is in the water, keep the
seacock closed until restarting the engine to prevent water from
flowing back into the cooling system. If the boat is not fitted with
a seacock, leave the water inlet hose disconnected and plugged.