Owner`s manual

MAINTENANCE

1. Attach a water hose to the boat's external water pickup, to

allow water to be supplied to the engine block during engine

warm‑up.

2. Open the water tap to supply enough flow to the sea pump so

that suction created by the sea pump, does not collapse the

supply hose.

3. Place the remote control in neutral position and start the

engine. Operate the engine at idle speed, in neutral, until the

engine reaches normal operating temperature.

4. Stop the engine and shut off the water.

5. Remove the fill plug from the top of the supercharger

gearcase.

6. Place a suitable container under the drain plug in the bottom

of the supercharger gearcase.

7. Remove the drain plug and drain the oil.

8. Clean and inspect the plug O‑rings, the gearcase fill and drain

hole threads and the plug threads.

9. Install the drain plug in the gearcase and torque to

specifications.

10.Fill the gearcase through the top fill hole with approximately

177 milliliters (6 oz.) of oil. The oil should cover half of the

sight‑glass in the gearcase.