Owner`s manual

MAINTENANCE

3. Remove the check valve assembly from the lower fitting and

drain the transmission fluid.

4. Re‑install the check valve assembly and the upper and lower

oil lines.

5. Fill the transmission through the dipstick tube with

approximately 1.9 liters (2 qt.) of Type F or FA transmission

fluid.

6. Attach a water hose to the boat's external water pickup, to

allow water to be supplied to the engine block during engine

warm‑up.

7. Open the water tap to supply enough flow to the sea pump so

that suction created by the sea pump, does not collapse the

supply hose.

8. Start the engine and let it run for at least two minutes at idle,

shifting the transmission from forward to reverse several

times.