Owner`s manual

MAINTENANCE

7. Reinstall the fill/vent screw by turning it all the way in, then

loosen one and a half turns.

CAUTION

Fill/Vent screw must be backed out one and a half (1‑1/2) turns

(after bottoming out) to vent pump reservoir. Failure to loosen

the screw could damage the pump.

CHECKING TRANSOM INPUT SHAFT BEARING HOUSING

(DRIVE-LINE MODELS ONLY)

1. Remove the level indication (middle) pipe plug from the input

shaft housing. Ensure that the gear lube level lies at the

bottom of the hole. If not, remove the pipe plug from the top

of the input shaft housing.

12868

a - Top pipe plug hole (Fill)

b - Middle pipe plug hole (Check level)

c - Bottom pipe plug hole (Drain)

Tube Ref No. Description Where Used Part No.

Torco MTF Gear Oil

Transom input shaft

bearing housing

Obtain

Locally

2. Fill the input shaft housing through the top pipe plug hole with

Torco MTF Gear Lube until gear lube flows from the middle

pipe plug hole (do not overfill).