Installation manual

- 11 -
5. Spray soapy water on tunnel grommet, both side
foam exhaust seals, ride plate seal and sides of
boat tunnel.
a
b
c
d
a - Tunnel Grommet
b - Boat Tunnel
c - Foam Exhaust Seals (One Each Side)
d - Ride Plate Seal
NOTE: When installing pump in tunnel, be sure
cables are below tunnel grommet flange on pump to
prevent pinching of cables between pump and boat.
6. Install jet pump by pushing unit through opening
in tunnel grommet. Ride plate seal should fit snug
in boat tunnel without any gaps along perimeter.
b
a
a - Jet Pump
b - Tunnel Grommet
7. Install gasket and cover (d) on jet pump. Align
holes in cover with locating pins in housing and
secure with four (4) M10 x 1.5 nuts .
NOTE: Before torquing fasteners, check side ex-
haust seals and ride plate seal for proper fit in tunnel.
8. Torque nuts to 47 Nm (35 lb ft).
b
a
a - Gasket and Cover
b - M10 x 1.5 Nuts (4)