User manual

- 23 -
10.2 Audio for Video with SONY Analog BetaCam Users
This example is based on Video NLE & DAW users who are using the Mykerinos board in conjunction with DUA II audio
interface and an Analog BetaCam video deck.
V IDEO & D IGITAL
A
UDIO
W
ORKSTATION
This example shows the following connections:
• The Analog BetaCam outputs are routed through the analog inputs of the DUA II to the Mykerinos input channels 1-4
(ADAT).
• The Mykerinos output channels 1-4 (ADAT) are routed through the analog outputs of the DUA II to the Analog
BetaCam inputs.
• The monitoring is provided by the front panel monitoring selection of the DUA II or through the stereo monitoring of the
Mykerinos board.
• The Mykerinos card (via VIDEO/TC bracket or the breakout cable - CVS1IN Input) and the Video Deck are connected
to the Video Ref. generator.
Note that each device should be connected to the video generator with its own cable.
Using the Loop-Through to connect the different devices is not recommended.
• The DUA II is set to ODI sync mode and AutoDetect SR mode.
• The DIP switches 1-8 must be set to: X – X – X – X – OFF – OFF – OFF – OFF.