Mykerinos The Audio Processing Board User Manual Version: DOC-2.
1 IMPORTANT NOTICE: Please read the following information very carefully before attempting any installation. Failure to comply with the precise instructions may result in damage to your Merging hardware. Please read this entire section of the manual carefully before installation. 1.1 STATIC DANGER NOTICE: Please note that the Mykerinos board contains delicate electronic components that can be damaged or even destroyed when exposed to static electricity.
2 Mykerinos Warranty Information This product is warranted to be free of defects in materials and workmanship for a period of one year from the date of purchase. Merging Technologies, Inc. extends this Limited Warranty to the original purchaser. In the event of a defect or failure to confirm to this Limited warranty, Merging Technologies, Inc. will repair or replace the product without charge within sixty (60) days.
3 Table of Contents 1 IMPORTANT NOTICE:..................................................................................................................2 1.1 1.2 STATIC DANGER NOTICE:.......................................................................................................2 INFORMATION FOR THE USER: .............................................................................................2 2 MYKERINOS WARRANTY INFORMATION .................................................................
11 TYPICAL AUDIO CONNECTIONS BETWEEN SPHYNX & MYKERINOS.....................23 11.1 11.2 11.3 12 MYKERINOS POWER CONSUMPTION .................................................................................26 12.1 12.2 12.3 12.4 12.5 12.6 12.7 13 AUDIO FOR VIDEO WITH SONY® DIGITAL BETACAM USERS ..................................................23 AUDIO FOR VIDEO WITH SONY® ANALOG BETACAM USERS .................................................24 MERGING TECHNOLOGIES PYRAMIX 3.X DAW SETUP................
4 Introduction This document presents and describes the third generation Merging hardware/software solution, a PCI based, high performance, cost effective audio processing card named MYKERINOS. 5 Mykerinos Features Overview Mykerinos is Merging's answer to create a leading edge high performance audio processing card solution.
6 Mykerinos Block Diagram Mykerinos Block Diagram MINI DIN 8 POS. 6.1 SSI Trimedia TM-1300 PLL Video Control Signals only DIFFERENT SIGNALS SDRAM Up to 32 MB Figure 1 - Mykerinos Block Diagram The Mykerinos board is based on the Philips Trimedia TM-1300 Chip and its associated SDRAM running at 144 MHz.
JP1 JP3 J4 JP2 J3 J2 JP4 JP7 U20 D1 Q2 Q1 U21 U7 JP5 U14 U19 U11 JP6 U22 U16 U17 U15 Figure 2 - Connectors & Jumpers layout Refer to the “Sync Features” and “Monitoring Headphone Features” chapters for additional information. 6.3 Mykerinos bracket view The following picture shows a view of the PCI bracket with the monitoring jack and the mini-Din connectors.
7 Sync Features Provision for all Video/TC related signals (VITC, LTC, and Video Sync) is both on a 8-pin Mini-Din connector (for external connection) and on a 16-pin header (for internal connection). The Video Out can also serve as VITC output and/or TC burn-in output. The Mykerinos board supports all standard Video formats such as PAL/NTSC, and all Tri-level HDTV formats as a reference synchronization source. VITC can only be extracted from standard video formats.
7.1.3 CVS OUT This signal outputs a composite video signal whose source can be software selected to be CVS1IN or CVS2IN. This signal may additionally carry a VITC and/or a time code "burn-in" video insert generated by Mykerinos. Note: CVSOUT provides a monitoring quality video output only and is not intended to be used as a loopthrough “black burst” output. 7.1.4 LTC IN LTC IN is a symmetrical input signal. It accepts an external SMPTE/EBU time code signal between 0.2 and 5 Vp-p. 7.1.
7.3 Video/TC Header Pin-out descriptions (JP2) The pins on the Video/TC header are as described below: Spare 2 500mA fused +5v ASC Out ATC Out RXD TXD GND Spare 1 CVS2/WCLK In & Out GND CVS1 In CVS Out LTC In LTC Out SCL SDA PCB Component side Figure 5 - Video/TC Header Pin-out When the Video/TC Header is used, be sure to not terminate twice the CVS1IN and CVS2IN inputs. Use only either the terminations on the Mykerinos board (JP4 & JP5) or those provided on the Video/TC Header.
8 Monitoring Headphone Features (J3) The monitoring output is based on a stereo 96kHz / 24 bit D/A (unbalanced). The output level is software controlled. Mykerinos revision D and above feature 2 new jumpers JP6 and JP7 on the left and right channels respectively. Opening these jumpers results in a 12 dB gain reduction on each monitoring channel. 8.1 Monitoring output characteristics The first graph shows the frequency response & the THD+N @ 48kHz and the second graph shows the Noise floor FFT @ 48kHz .
9 Mykerinos Modular I/O Daughter cards One core feature of Mykerinos’ architecture is to break it into two parts: the portion that plugs into the PCI connector of the PC and the I/O daughter card that contains the physical connectors to the outside world. This allows for potentially many system applications without committing the design to any specific I/O configurations. 9.
The optical ADAT daughter card is supplied with two 2-meter optical fiber cables. Other length (up to 10 meter) can be ordered from your authorized Merging dealer. For long distance optical connections, Merging provides the Onouris long distance system, which converts the ADAT plastic light-pipe into a signal suitable for glass fiber connection up to 1000 meters. Cables with various glass fiber lengths can also be supplied. 9.
9.3 AES-EBU, SDIF, TDIF I/O Daughter Card The Mykerinos AES-EBU Daughter board offers 24 channels of digital I/O over 12 AES-EBU input and output pairs. 8 channels feature real-time Sampling Rate Conversion from 32 to 96 kHz, which may be inserted either in the input or output signal path under software control. Both “single wire” (32 to 96 kHz) and “dual wire” (64 to 192 kHz) modes are supported under software control.
The table below is a summary of the different possibilities allowed with these 4 daughter cards. AES without SRC AES with SRC SDIF TDIF FRONT CH 1 – 8 CH 1 – 8 CH 1 – 4 (DSD only) CH 1 – 8 REAR 0 CH 9 – 16 CH 9 –16 CH 5 – 8 (DSD only) CH 9 – 16 REAR 1 CH 17 – 24 CH 17 – 24 CH 17 – 24 The AES with SRC provides 6 (Sony mode) or 4 (P3D mode) I/O of DSD channels through connectors Rear 0 and Rear 1.
9.4 DUAL Daughter Card The Dual DC is the most cost-effective I/O daughter card for Pyramix. It is an ideal I/O solution for mixed analog/digital requirements, as encountered in Broadcast production, and Video/Film postproduction environments. It allows the direct connecting of up to two electrodynamics or condenser microphones, typically for quick and easy voice-over recording. 9.4.
9.4.2 Front connector This DB25 connector is for the DUAL ANALOG I/O breakout cable, as shown in the following drawing. ANALOG IN 1 ANALOG IN 2 ANALOG IN 3 ANALOG IN 4 ANALOG I/O ANALOG OUT 1 ANALOG OUT 2 ANALOG OUT 3 ANALOG OUT 4 ANALOG IN 1 - 4 Any professional level balanced audio output can be connected to the analog line inputs of the DUAL Daughter card. Input levels are selectable from consumer level (–10 dBV) up to professional level (+4 dBu).
9.5 Breakout cable connectors for AES, SDIF, TDIF and DUAL daughter cards 1 13 14 25 DB25 Male Connector (I/O) 2 1 1 3 XLR Female Connector (Inputs) 2 3 XLR Male Connector (Outputs) 9.5.
10 Typical Audio Connections between DUA II & Mykerinos This section will display some typical audio connection scenarios for DUA II and Mykerinos. 10.1 Audio for Video with SONY Digital BetaCam Users This example is based on Video NLE & DAW users who are using the Mykerinos in conjunction with a DUA II audio interface and a Digital BetaCam video deck.
10.2 Audio for Video with SONY Analog BetaCam Users This example is based on Video NLE & DAW users who are using the Mykerinos board in conjunction with DUA II audio interface and an Analog BetaCam video deck. VIDEO & DIGITAL AUDIO WORKSTATION This example shows the following connections: • • • • • • The Analog BetaCam outputs are routed through the analog inputs of the DUA II to the Mykerinos input channels 1-4 (ADAT).
10.3 Merging Technologies Pyramix 3.x DAW with Surround Monitoring This example is based on a typical Pyramix analog/digital audio studio with both types of devices and a surround monitoring system.
11 Typical Audio Connections between Sphynx & Mykerinos This section will show some typical audio connection scenarios for the Sphynx Audio Interface and the Mykerinos board. 11.1 Audio for Video with SONY® Digital BetaCam Users This example is based on Video NLE & DAW users who are using the Mykerinos board in conjunction with the Sphynx Audio Interface and a Digital BetaCam video deck.
11.2 Audio for Video with SONY® Analog BetaCam Users This example is based on Video NLE & DAW users who are using the Mykerinos board in conjunction with the Sphynx Audio Interface and an Analog BetaCam video deck. VIDEO & DIGITAL AUDIO W ORKSTATION This example shows the following connections: • • • • • The monitoring is done by the front panel Monitoring selection &output or through the stereo monitoring connector of the Mykerinos board.
11.3 Merging Technologies Pyramix 3.x DAW Setup This example is based on a typical Pyramix analog/digital audio studio with both types of devices. This configuration allows up to 8 inputs and 8 outputs in ‘x2’ SR mode. MERGING PYRAMIX 3 W ORKSTATION This example shows the following connections: • • • All monitoring is done by the front panel monitoring selection & output and/or the analog output modules or the stereo monitoring of Mykerinos.
12 Mykerinos Power Consumption The following tables indicate the maximum power consumption from the +5V, -12V and +12V power rails of the PC for the Mykerinos itself and for the daughter cards only. 12.1 Mykerinos motherboard (alone) At TA = 28 °C. The Boot and Typical values for the current measurements have been made from the +5V. Parameter MYK_MB1 Boot Typical MYK_MB2 Boot Typical MYK_MB3 Boot Typical MYK_MB4 Boot Typical Unit Current 560 720 630 920 630 950 670 1000 mA Power 2.8 4 3.
12.4 AES-EBU DSD (w/o SRC) daughter card At TA = 28 °C. Parameter Unit +5 Values +3.3 +12 -12 Current 200 150 na na mA Power 1 0.5 na na W 12.5 AES-EBU SRC daughter card At TA = 28 °C. Parameter Unit +5 Values +3.3 +12 -12 Current 500 150 na na mA Power 2.5 0.5 na na W 12.6 SDIF or TDIF daughter card At TA = 28 °C. Parameter Unit +5 Values +3.3 +12 -12 Current 200 150 na na mA Power 1 0.5 na na W 12.7 DUAL (Analog – AES/EBU) daughter card At TA = 28 °C.
13 Contacting Merging For all general or sales inquiries: In Europe, Africa and Asia contact our Swiss Office: Merging Technologies SA Le Verney 1070 Puidoux Switzerland Phone: +41 21 946 0444 Fax: +41 21 946 0445 In the Americas, contact our Illinois Office: Merging Technologies 3340 Dundee Road Suite 2C-3 Northbrook, IL 60062 United States of America Phone: +1 847 272 0500 Fax: +1 847 272 0597 Merging website: www.merging.