User manual

User Manual : Strip and Bus Tools - Plug-ins
User Manual
204
both assigned to group one. The scale factor of the gain of strip tools #2 is set
to 2. Now when you change the gain of strip tools #1 by 1 dB, the gain of strip
tools #2 will change by 2 dB’s.
Invert Also works only on continuous controls. It inverts the effect of the movement
for this control caused by another group member or vice versa. E.g, assume
the input gain of strip tools #1 and the input gain of strip tools #2 are both
assigned to group one. The invert button of the gain of strip tools #2 is on. Now
when you increase the gain of strip tools #1 by 1 dB, the gain of strip tools #2
will diminished by 1 dB.
Automation mode switches
Please see: Automation on page 192 for a description of the automation mode switches.
When a grouped control is clicked, all other members of the group are shown with a yellow box around
them.
Offset
If controls are offset when grouping is turned on, they retain the offset as shown here.
The red bar at the top of the strip indicates it is selected. The grayed out knob is the one which was
right-clicked.