Installation guide

Installation Guide : MassCore - Ravenna
9 - 24
4. Remove the NET-MSC-GBEX1 card from its protective anti-static envelope and align it with the vacant PCIe
slot as shown below.
5. Push down, gently at first, ensuring you have the pins aligned correctly with the slot, and then apply more
pressure to slot the card fully home.
6. Use the screw which was used to retain the backing plate to secure the card in place and check that the card
sits comfortably.
7. Finally, replace the case cover(s) and switch the machine back on at the socket.
8. At the next power up and boot Windows will discover the Merging Ethernet PCIe card.
Pyramix V8 can now be installed.
Required Software
In order to operate Pyramix with Ravenna and Horus, Pyramix V8 must be installed. The Pyramix v8 installer
includes; the MassCore-Ravenna Connect utility, MT Discovery tool along with Apple bonjour.
Note: Driver signing. Please tick Always trust “Merging Technologies” when the first
warning message about unsigned drivers appears.
Enter your Pyramix keys
Launch MTSecurity settings and enter your Pyramix V8 keys. Please see Entering your Key(s) on page 19
Note: Pyramix V7.1 keys will only be valid with the Pyramix V8 beta versions.
Install MassCore
Please see: MassCore Installation on page 21
Note: A valid MassCore (Base) key is mandatory.
The MassCore key is held on the Safenet dongle. Please make sure that you are in posses-
sion of a dongle and valid keys in order to operate Pyramix in MassCore-Ravenna mode.