Owner's manual

M130 – T/C Calibrator
Instruction Manual Z1017-IR
E.O. 6566 Sept. 2008
www.meriam.com
Page 11 of 21
SIM (MANUAL) SETUP: Simulation Mode’s Manual menu structure
VALUE
ADJUST Press ENTER & use increment or decrement group
keys to set a numeric value, press ENTER to start
UNITS Select desired unit of simulation
C engineering units are ºC
F engineering units are ºF
R engineering units are ºR
K engineering units are K
TC TYPE Select T/C type or mV
mV engineering units are mV
B engineering units are temperature only
E engineering units are temperature only
J engineering units are temperature only
K engineering units are temperature only
N engineering units are temperature only
R engineering units are temperature only
S engineering units are temperature only
T engineering units are temperature only
0 – 100 Outputs 0% and 100% of setup
START Starts 0% of range; ENTER toggles to 100%, 0%...
UNITS Edit units corresponding to 0 – 100, same as above
TC TYPE Select T/C type, same as above
URV Upper Range Value for T/C and unit selected
press enter & use +/ – keys
LRV Lower Range Value for T/C and unit selected
press enter & use +/ – keys
STEP 25% Outputs 0, 25, 50, 75 and 100% of setup below
START Starts 0%, ENTER increases 25% to 100% & back
UNITS Edit unit for STEP 25%, same as above
TC Select T/C type, same as above
URV Upper Range Value for T/C and unit selected
press enter & use +/ – keys
LRV Lower Range Value for T/C and unit selected
press enter & use +/ – keys
Notes: 1. Main and submenus are continuous, scrolling menus. Use W or X
to scroll through the menus.
2. Use SETUP key to discontinue simulation activity.