Owner's manual

M130 – T/C Calibrator
Instruction Manual Z1017-IR
E.O. 6566 Sept. 2008
www.meriam.com
Page 13 of 21
K engineering units are K
TC TYPE Select T/C type or mV
mV engineering units are mV only
B engineering units are temperature only
E engineering units are temperature only
J engineering units are temperature only
K engineering units are temperature only
N engineering units are temperature only
R engineering units are temperature only
S engineering units are temperature only
T engineering units are temperature only
URV Upper Range Value for T/C and unit selected,
press enter & use +/ – keys
LRV Lower Range Value for T/C and unit selected,
press enter & use +/ – keys
UP TIME Select desired ramp time from LRV to URV,
press enter & use +/ – keys
DN TIME Select desired ramp time from URV to LRV,
press enter & use +/ – keys
DELAY Select desired start delay time for test,
press enter & use +/ – keys
A.RAMP 2
same as A.RAMP 1 above
A. RAMP 3
same as A.RAMP 1 above
Note: 1. Main and submenus are continuous, scrolling menus. Use W or X
to scroll through the menus.
2. Use SETUP key to discontinue simulation activity.