Installation manual

9
When using an external sensor, the flow temperature is automatically calculated according
to the external temperature and the K coefficient that has been set. If you are also set the
function YSELF the curve will be controlled and in case modified by algorithm inside of
remote control in order to ensure optimal comfort and maximum energy savings.
If you put in action the YSELF function also the AMBON function must be activated.
The AMBON function is integrated in the remote control.
51
12
9
12
18
0
3
6
PRESS THE BUTTON IP
MORE THAN 3 SECONDS TO
ENTER IN INFO MODALITY
PRESS THE BUTTON OK FOR MOVE FROM A WINDOW TO ANOTHER TILL
ARRIVE TO THE “K REG” FUNCTION
WITH UP E DOWN BUTTONS IT’S POSSIBLE TO CHANGE THE
EXTERNAL TEMPERATURE CURVE. REFER FUNCTIONING CURVES
FIG.3
PRESS THE BUTTON OK FOR MOVE FROM A WINDOW TO ANOTHER
BUILDING SIZE PARAMETER: WITH UP AND DOWN BUTTONS IT’S
POSSIBLE TO CHANGE THE VALUE. A high value is associated with
buiding/heating system with high thermal inertia
PRESS OK BUTTON TO MOVE AT FOLLOWING WINDOW
PRESS OK BUTTON TO MOVE AT FOLLOWING WINDOW
AMBON
. WITH UP AND DOWN BUTTONS IT’S POSSIBLE TO CHOOSE
ENABLE 1 O DISABLING 0
YSELF
. WITH UP AND DOWN BUTTONS IT’S POSSIBLE TO CHOOSE
ENABLE
1
O DISAB
LING
0
PRESS IP BUTTON TO EXIT FROM THE WINDOW INFO
ENABLE ANTIFREEZE HOUSE FUNCTION. WITH UP AND DOWN
BUTTONS IT’S POSSIBLE TO CHOOSE ENABLE 1 O DISABLING 0
PRESS THE BUTTON OK FOR MOVE FROM A WINDOW TO ANOTHER