Operation Manual

Customise 518 using Type 24
518 User Guide
• Source-Logo-input mapping as shown below.
Source Logo Type 0
Input
Type 1
Input
Type 2
Input
Comms
type
CD CD D1 D1 D1 1
Radio RD D1 D1 N 2
LP LP D1 D1 N –
TV TV D1 D1 N –
Tape1 T1 D2 D1 D2 –
Tape2 T2 D3 D1 D3 –
CDR CR D1 D1 N –
Cable Cb D1 D1 N –
Text Tx D1 D1 N –
VCR1 V1 D1 D1 N –
VCR2 V2 D1 D1 N –
LD LD OP D1 OP –
Selecting Types
1. Switch off any power amplifiers that are connected to the system.
2. Switch off the 518 using the power switch on the back.
3. While pressing the Off key on the 518 front panel, switch the power on
again. The display will read:
4. Release the Off key
5. Use the front-panel
and Volume keys to move the selection
between Types 0 – 2.
6. When you have the Type you want displayed, wait one second for 518
to action the choice.
7. Switch off the 518 using the power switch on the back.
8. After half a second, switch the 518 power on again to restore Normal
mode.
Customising using Config
In Config you can review and change settings to do with communications,
control and the hardware options you have. In Config you also make
choices about the number and types of sources, what the display shows
when you select them etc. The 518 is initially programmed to Type 1 and
all Types set up the source configuration as shown in the previous Tables.
How to use Config
1. Switch off any power amplifiers that are connected to the system.
2. Switch off the 518 using the power switch on the back.
3. While pressing the Display key on the 518 front panel, switch the
power on again. The display will read:
4. Release the Display key, the display will show:
Type
1
Config