Operation Manual

Customising 518 using Config 25

518 User Guide

Selecting the controller mode

In Config mode:

1. Press Display until you see a display like:

2. Use the

and , Volume keys to choose between:

• Auto, meaning configuring can be automatic

• Cont, meaning the 518 will be the system controller

• N.Con, meaning the 518 will not be the controller

Setting the system address for 518

In Config mode:

1. Press Display until you see a display like:

This means the system address is 1. The Meridian 500 Comms system

allows for up to eight systems operating on the same network. Unless you

are setting up a Multiroom system, or are advised to do so by Meridian

support personnel, we suggest you leave this on address 1.

Setting the product address for 518

In Config mode:

1. Press Display until you see a display like:

This means the product address is 1. The Meridian 500 Comms system

allows for up to eight products of the same type operating on the network.

Unless you are setting up a Multiroom system, or are advised to do so by

Meridian support personnel, we suggest you leave this on address 1.

Note When customisation is complete, switch the power off and then on

again to restore Normal mode and to save what you have done.

Setting the Standby mode for 518

In Config mode:

1. Press Display until you see a display like:

This means that Standby mode is available. To prevent Standby chose N.

2. Use the

and , Volume keys to choose between Yes or No.

Setting the Bypass option for 518

In Config mode:

1. Press Display until you see a display like:

This means that Bypass is available. Bypass prevents the 518 operating

as a volume control and is therefore it is highly undesirable to access it by

mistake if you are using 518 to control volume.

2. Use the

and , Volume keys to choose between Yes or No.

Auto

SA=1

PA=1

Stby

Bypass