User guide

Configuring the DVD player
52
Choosing standard settings
The DVD player provides three standard settings, called Types,
which configure the 596 into the most commonly needed
configurations.
Choosing one of the three Types overrides any other
configuration you may have performed, and so can be used to
reset the configuration of the unit.
The types are summarised in the following table:
Type Video Audio MHR
0 S-video PCM 96kHz Auto
1 S-video Bitstream 96kHz Auto
2 S-video Bitstream 96kHz On
To restore the standard settings
● Switch the 596 to standby.
● Hold down Off (front panel).
After a short delay the display
will show:
Type,wait...
● Press [ or ] on the front panel to change the Type
number.
For example, if you select Type 1
the display shows:
Type 1
● Wait until the display shows:
Typing, wait
The display then shows:
Type 1
● Press Off to switch back to standby.
● Switch on again to use the 596 with the standard setting you
have selected.