User guide

Configuring the DVD player
53
Configuring the 596 DVD Player
To configure specific options
● Highlight Meridian setup in the Setup menu, and press
Enter.
The Meridian setup menu will be displayed:
To set configuration options
The configuration options are generally set to an appropriate
value when you reset the 596 to the standard settings, and you
should not normally need to alter them; see Choosing standard
settings, page 52.
The options are summarised in the following table for advanced
use:
Option Default Description
Diagnostics No Set to Yes for a diagnostic
display on the front-panel
display.
System address 1 Set to a value from 1 to 8.
Product address 1 Set to a value from 1 to 8.
Controller Auto Specifies whether the DVD
player is controller, not
controller, or set automatically.
Start source DVD Specifies which source is
selected when switching on from
standby.
Vol display No Specifies whether the DVD
player displays the volume for
the system.
Fan As Set to Always to keep the fan
required permanently on, or As required
to use it when necessary.
Source config Allows you to configure the
sources; see below.