User guide

Configuring the DVD player

To configure the sources

If you are using the 596 DVD Player as the controller in your

Meridian system, you can use the Source config option on the

Meridian Setup menu to configure each of the sources in your

system.

● Highlight Source config in the Meridian Setup menu, and

press Enter.

The Source configuration menu is displayed:

For each source you want to configure:

● Press the source key on the remote corresponding to the

source you want to configure.

The Category, Address, and SCART switch options show the

current values defined for that source. The SCART switch

option only appears with the SCART version of the 596.

To change any option:

● Highlight the corresponding option in the Source

configuration menu and press Enter, select the value you

want to use, and press Enter to select it.

The Category identifies the type of Meridian product selected

by the corresponding source. Specify -C for the current product,

1C for a Meridian CD player, 2C for a Meridian tuner, 3C for

another Meridian DVD player, or NC for a non Meridian product

such as a TV.

Normally the Address should be set to 1A. However if you have

more than one Meridian product of the same type in your

system you can use different source keys to select between

them by assigning them different addresses. For example if you

have two Meridian DVD players, assign one of them address 1A

and the other address 2A.

For information about using the SCART switch option see To

set up SCART switching, page 36.