User guide

24
Installing the 810
Scaler
Control connections
Use this connection To connect to this
RS232 Projector The RS232-C input on the 810 D-ILA Projector.
RS232 Control A controller, such as a Crestron, for remote control of the 810 video system. For more
information see the 810 RS232 Interface Guide , available separately.
RS232 Maintenance (front panel) For firmware updates.
Meridian Comms Meridian G Series or 800 Series equipment, or Meridian DSP loudspeakers.
IR IN A G12 IR Receiver, or approved alternative infra-red repeater.
Trigger 1, Trigger 2, Trigger 3 Other equipment, via mono 3.5mm jack plug outputs (tip hot) providing 12VDC. They
are always low in standby. By default they are high for all sources, so can be used to
bring another product out of standby. Alternatively you can program them to be high
for specific sources; eg to control a projection screen. In systems with an anamorphic
lens sled, Trigger 1 and Trigger 2 are dedicated to Sled Power and Sled Actuate
respectively.
Ethernet For future expansion.
USB Host (back and front panel) For future expansion.
The RS232 connections should be made using RS232
Male-Male Null Modem serial cables.