User guide

28
Setting up the 810
System
Configuration Wizard
The Configuration Wizard leads you through the correct
sequence to configure your Scaler/Projector.
Alternatively, you can skip between the configuration
stages, which allow you to reset the configuration, or
configure the sources or other settings of the Scaler/
Projector.
To run the Configuration Wizard
If necessary press Power to put the scaler into
standby.
Press More.
The display shows:
7IZARD
Press Wizard.
Follow the sequence of configuration stages described
in the following pages, pressing Next to proceed after
completing each stage.
At any stage in the Configuration Wizard the following
options are available:
To do this Press
Go back to an earlier configuration option Back
Go to the next configuration option Skip
Return to the title screen for the stage Home
Exit from the configuration menus Power
•
•
•