Installation Instructions
23
24
INSTALLATION GUIDE
DETAIL A
Short Course
1. Install panel on the upper starter strip at the transition so the under lap is flush with the
inside of the 903 barge channel.
2. Install full panel covering the underlay on the transition panel so the headcheck is past
the upper starter strip.
3. Cut o excess material above 901 short course as not to interfere with the next course
of panels.
4. Snap horizontal line on transition panel (
FIG. 07.B ) where the short course will start.
5. Align 901 short course on transition panel line.
6. Fasten through the panel into the deck using #12 x 1 ½” screws or 8D ringshank nails.
7. Continue panel installation across short course at the transition (FIG. 07.C).
* Water channel flush with oset in barge.
NOTES
Underlayment
903 Barge Cover
Underlayment
Top course of panels
901 Short course
FIG. 07.A
FIG. 07.B
FIG. 07.C
DETAIL A CONTINUED
Short Course
903 Barge Cover
903 Barge Cover