Installation Instructions

35
36
INSTALLATION GUIDE
DETAIL B
Ridge Ventilation
1. Short course 6" past both sides of o ridge vent and fasten to deck with #12 x 1 ½"
screws.
2. Cut and fit 7 shape panel up side and across the top of the o ridge vent.
3. Cut and fit 7 shape panel to closely fit the left side of the o ridge vent.
4. Finish with 3/4" stitch screws into the short course below, careful not to penetrate o
ridge vent.
1. Cut 1” opening on both sides of the ridge.
2. Install last course of panels up to the opening on both sides of the ridge.
3. Install Ridge Vent on both sides of the ridge so the ridge vent is touching at the center
of the ridge.
4. Install Shingle Trim 400 over the top of the ridge vent securing with #12 x 1 ½” screws
or ring shank nails.
NOTES NOTES
FIG. 11.G FIG. 11.H
Shingle Trim 400
Underlayment
Deck Opening
Ridge Vent
Roof Deck
Panel
Rafter
DETAIL A CONTINUED
O Ridge Ventilation
7 shape panel
901 Short Course