Installation guide

I n s t a l l i n g t h e

d i g i t a l s u r r o u n d

c o n t r o l l e r

1 2

To connect the G68 to Meridian DSP loudspeakers (home run)

G68 Digital Surround Controller

SPEAKERLINK

OUTPUTS

SPEAKERLINK LEAD

DSP Loudspeaker – Centre (Slave)

SPEAKERLINK

INPUT OUTPUT

DSP Subwoofer – Sub (Slave)

DSP Loudspeaker – Main Left (Master)

SPEAKERLINK

INPUT OUTPUT

DSP Loudspeaker – Main Right (Slave)

SPEAKERLINK

INPUT OUTPUT

DSP Loudspeaker – Rear Left (Slave)

SPEAKERLINK

INPUT OUTPUT

DSP Loudspeaker – Rear Right (Slave)

SPEAKERLINK

INPUT OUTPUT

SPEAKERLINK

INPUT OUTPUT

This is an alternative to the “daisy chain” wiring configuration

shown in the previous section.

The G68 automatically assumes that the main left speaker is the

master, unless it is analogue, in which case the DSP centre, left

side, or left rear is used in order of priority (unless explicitly set

differently in the Meridian Configuration program).

• Connect the appropriate

SpeakerLink output on the lower row

of the G68 to the master digital speaker (typically the main left

speaker), using a Meridian SpeakerLink lead.

• Connect the appropriate SpeakerLink outputs on the G68 to each

of the remaining speakers, using a Meridian SpeakerLink lead.

The speakers should then be configured appropriately as master

and slaves, and Left, Right, Centre, Surround; see

Meridian DSP

Loudspeaker User Guide

for more details.

Alternatively you can use standard CAT5 network cables instead of

SpeakerLink leads.