MT-202 MR-202 MT-202 Operating ~ 33mm(L)×33mm(W)×15mm（H） Antenna (Built in) Steering Dual Rate Lever (D/R) Steering Trim Lerer (CH1) CONNECTION 1 B Connects to the steering servo Motor connector Battery connector Power switch 3 2 1
MT-202： 1.CH1(Steering) Trim： Steering neutral adjustments can be made by moving the steering trim lever to the left or right. When you install a servo, always check to be sure the servo is at its neutral position. Adjust the servo horn position and linkage so both are parallel. Be sure the steering trim on the transmitter is at the neutral position. 2.CH1(Steering Dual-Rate)D/R： Use this function to adjust the steering travel of your model.
FCC Statement： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference，and (2) this device must accept any interference received, including interference that may cause undesired operation.
