Operating instructions

ESTING THE DOOR

isable all locks and remove any ropes connected to

the garage door.

Complete the following test to ensure your door is well

alanced, and not sticking or binding:

• Lift the door to about halfway and then release it. The door

should remain spring balanced.

NOTE: The spring should hold the door at any open

osition without creeping up or down.

• Raise and lower the door to discover if there are any

sticking or binding points.

• If your door does not hold in place or the door binds or

sticks, call a qualified door technician before automating

the door.

INSTALLING THE WEIGHT BAR (PROVIDED)

• Install the stop collar on the opposite end to where the

opener is to be installed.

• Fit the stop collar hard against the boss of the door

drum. Ensure the U-bolt holding the door axle to the door

bracket is tightly secured.

INSTALLING THE STOP COLLAR

SAFETY CHECK!

Is the stop collar

installed?

YES: proceed to the next

step

NO: install the stop collar

before proceeding

• Place the weight bar in the centre of the door.

• If the door curtain does not have a lifting handle you

will need to drill two 5.5mm holes through the two

marked positions, then place the weight bar on the

inside of the door.

• Use the 5mm bolts, washers and nuts (provided) to

fasten the weight bar in place.

NOTE: If the door has a lifting handle, remove the

handle, nuts & bolts. Place weight bar over the

handle holes, insert extended bolts through the

weight bar & fasten handle back in place.