Operating instructions
ASSEMBLE DOOR ARM
A
. ONE-PIECE DOOR INSTALLATION:
Fasten the straight (1) and curved (2) door arm sections
together to the longest possible length (with a 2 or 3 hole
overlap) using carriage bolts (3), lock washers (4) and hex
n
uts (5). With the door closed connect the straight door arm
section (1) to the door bracket with clevis pin (6). Secure with
ring fastener (7). Disconnect the inner and outer trolley. Slide
the outer trolley back toward the opener and join the curved
arm (2) to the connector hole in the trolley (8) with clevis pin
(6). It may be necessary to lift the door slightly to make the
connection. Secure with ring fastener (7).
NOTE: When setting the up limit, the door should not
have a “backward” slant when fully open. A slight
backward slant (9) will cause unnecessary bucking
and/or jerking whilst operating the door from the fully
open position.
B. SECTIONAL DOOR INSTALLATION:
Connect according to Figure B, then proceed to
Section 21.
7
6
2
9
1
8
4
5
3
A
4
3
5
B
7
6
6
1
2
20
There are 2 screw terminals on the back of the door
control . Strip about 6mm (1/4") of insulation from bell wire.
Separate wires enough to connect the white/red wire to
RED terminal screw 1 and the white wire to WHT terminal
screw 2.
Fasten the door control to an inside garage wall with sheet
metal screws (3) provided. Drill 4mm (5/32") holes and
use anchors if installing into a plaster wall. A convenient
place is beside the service door and out of reach of
children.
Run the bell wire up the wall and across the ceiling to the
garage door opener. Use insulated staples to secure wire.
The receiver quick connect terminals are located behind
the light lens of the opener. Connect the bell wire to the
terminals as follows: white/red to red (1) and white to white
(2) as shown.
Operation of the Door Control
Press to open or close the door. Press again to stop the
door while moving.
2
3
1
W
H
T
2
R
E
D
1
1
4
6mm
1
3
2
6
0 s
1
20 s
1
80 s
O
–
L
O
C
K
L
I
G
H
T
Push Bar Cover
1
2
R
ED WHITE
21
Locate door control where the garage door
is visible, away from door and door
hardware and out of the reach of children.
Mount at least 1.5 m (5 feet) above the floor.
Serious personal injury from a moving garage door
may result from misuse of opener. Do not allow
children to operate the door control or transmitter.
Permanently fasten the caution label to the wall near
the door control as a reminder of safe operating
procedures.
8
INSTALL DOOR CONTROL (OPTIONAL ACCESSORY)