Owner`s manual

6
0 s
1
20s
180 s
O
–
grey
white
2
white
M
T60/P
MT600 / MT1000
M
T5580
1. grey
2. white
white wires
t
wisted together
white/black
wires twisted
together
3
grey
white wires
white/black
wires
white/black
wires twisted
t
ogether
white wires
twisted together
MR800a /MR600a
grey
white
white wires
twisted together
white/black
wires twisted
together
2
1
3
Wiring Connections Merlin Professional
MT60/P connections
Open the lens cover on the front of the unit to access the
connection terminals. Strip all wires back about 10mm
t
wist the two (-) wires together, then twist the the two (+)
wires together. Trim the twisted wires to approximately
6
mm. Use a small screwdriver or pen to hold down the
spring terminals, insert the (+) wires into the grey terminal
(1), then terminate the (-) (only) wires into the white termi-
nal (2).
MT5580 (all models) connection
Locate the connection terminals on the back of the unit.
Strip all wires back about 10mm, twist the two (-) wires
together, then twist the two (+) wires together. Trim the
twisted wires to approximately 6mm. Use a small screw-
driver or pen to hold down the spring terminals, insert the
(+) wires into the grey terminal, then terminate the (-)
wires into the white terminal.
MT600 / MT1000 connections
Locate the terminals on the back of the unit. Strip all wires
back about 10mm, twist the two (-) wires together, then
twist the two (+) wires together. the twisted wires to
approximately 6mm. Use a small screwdriver or pen to
hold down the spring terminals, insert the (+) wires into the
grey terminal (3), then terminate the (-) wires into the white
terminal (2).
NOTE: Optional connections: Connect the (-) wires and
(+) wires into separate terminal on the back of the unit as
illustrated above. This may be required if larger diameter
cable extensions have been used to extend wiring.
Setting Autoclose MR600A, MR800A/ MT1000 (ONLY)
Auto Close NOTE:
Ensure that the trim pot is set to 0s when terminating cables. Beams must be uninterrupted for up to five minutes
after turning on to initialise. (The Trim pot should not be adjusted during this 5 minute initialising period)
.
Note: After the beams are initialised they are fail safe i.e. if they removed, the motor will not close until the
beams are re(-)installed.
MR600a / MR800a connections
Gently lift the diffuser on the base of the motor to access
the terminals. Strip all wires back about 10mm, twist the
two (-) wires together, then twist the two (+) wires togeth-
er. Trim the twisted wires to approximately 6mm. Use a
small screwdriver or pen to hold down the spring termi-
nals, insert the (+) wires into the grey terminal, then termi-
nate the (-) wires into the white terminal.
WARNING: Door may operate unexpectedly, therefore do not allow anything to stay in the path of the door.
(+) Wires
from 771ANZ
(-) Wires
from 771ANZ
(+) Wires
from 771ANZ
(-) Wires
from 771ANZ
(+) Wires
from 771ANZ
(-) Wires
from 771ANZ
(+) Wires
from 771ANZ
(-) Wires
from 771ANZ
2