Specifications

Program your Opener & Remote
Activate the opener only when door is in full view, free of
obstruction and properly adjusted. No one should enter or
leave garage while door is in motion. Do not allow children
to operate push button(s) or remote(s). Do not allow
children to play near the door.
Your garage door opener receiver and remote control
transmitter are set to a matching code. If you purchase
additional remote controls, the garage door opener must be
programmed to accept the new remote code.
Program the Receiver to Match Additional Remote Control
Codes:
Using the orange “LEARN” Button:
1. Press and release the orange “learn” button on the opener.
The learn indicator light will glow steadily for 30 seconds (1).
2. Within 30 seconds, press and hold the button on the hand-
held remote that you wish to operate your garage door (2).
3. Release the button when the opener light blinks. It has
learned the code. If the light bulb is not installed, two clicks
will be heard (3).
Using the Motion Detecting Control Panel
(optional accessory):
1. Press and hold the button on the hand-held remote that you
wish to operate your garage door (4).
2. While holding the remote button, press and hold the LIGHT
button on the Motion Detecting Control Panel (5).
3. Continue holding both buttons while you press the push bar
on the Motion Detecting Control Panel (all three buttons are
held) (6).
4. Release buttons when the opener light blinks. It has learned
the code. If the light bulb is not installed, two clicks will be
heard (7).
Now the opener will operate when the remote control push
button is pressed. If you release the remote control push button
before the opener light flashes, the opener has not learned the
code.
To Erase all Remote Control Codes:
To deactivate any unwanted remote, first erase all codes: Press
and hold the orange “learn” button on opener until the learn
indicator light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless
entry you wish to use.
2 or 3-Channel Remote (optional accessory):
If provided with your garage door opener, the large or center
button is factory programmed to operate it. Additional buttons on
any rolling code 2 or 3-channel remote or
mini-remote can be programmed to operate this or other rolling
code garage door openers.
1
3
2
7
4
1
3
2
60 s
120 s
180 s
O
–
L
IG
H
T
5
LOCK
L
IG
H
T
LOCK
6
L
i
f
t
M
a
s
t
e
r
L
i
f
t
M
a
s
t
e
r
22
9
optional
optional