Specifications

Setting the Limits
Travel limits regulate the points at which the door will stop when moving
up or down. Follow the steps below to set the limits.
You may program the limits automatically or manually.
Setting the limits automatically:
1. Press and hold the black button (1) until the yellow indicator light (3)
starts flashing slowly and then release.
2. Push and hold the black button (1) until the door reaches the desired
open position. Adjust the position of the door by using the black (1) and
orange (2) buttons. Black moves the door UP, orange moves the door
DOWN.
3. Push the programmed remote control (4) or push bar on the door
control that was shipped with your opener. This sets the full UP (open)
position. The door will travel to the floor and reverse back to the UP
(open) position. The opener has learned its travel limits. Check to be
sure the door is high enough for your vehicle. Adjust if necessary.
4. The indicator light (3) will stop flashing when the limits have been learned. If the door stops or reverses before it reaches the
floor repeat steps 1-3 immediately. If this does not set the limits, proceed with setting the limits manually. The force MUST be
learned in order to properly complete the setting of the limits.
Setting the limits manually:
1. Press and hold the black button until the yellow indicator light starts flashing slowly then release.
2. Adjust the position of the door by using the black and orange buttons. Black moves the door UP (open) and orange moves
the door DOWN (close). Check to be sure the door opens high enough for your vehicle.
3. Push the remote control or door control. This sets the UP (open) limit and begins closing the door.
Immediately press either the orange or the black button. The door will stop.
Adjust the desired DOWN (close) limit position using the black and orange buttons. Check to be sure the door is fully closed
without applying excessive pressure on the rail (rail should not bow upwards and the chain/belt should not sag or droop below
the rail). Push the remote control or door control. This sets the DOWN (close) limit and begins opening the door.
NOTE: If neither the black or the orange button is pressed, the door will reverse off the floor and the DOWN travel limit will
beset automatically.
4. Open and close the door with the remote control or door control 2 or 3 times.
• If the door does not stop in the desired UP (open) position or reverses before the door stops at the DOWN (close) position, set
the Force, see adjustment steps 26 and 27.
• If the door stops in both the desired UP (open) and DOWN (close) positions, proceed to Test the Safety Reversal System.
Using the Motion Detecting Control Panel
(optional accessory)
Press the push bar (1) to open or close the door. Press again to stop the door.
Light feature
Press the light button to turn the opener light on or off. It will not control the opener lights when the
door is in motion. If you turn it on and then activate the opener, the light will remain on for 2 1/2
minutes. Press again to turn it off sooner. The 2 1/2 minute interval can be changed to 1-1/2, 3-1/2
or 4-1/2 minutes as follows: Press and hold the Lock button until the light blinks(about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light
will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for 3-1/2 minute interval, etc., up
to a maximum of four blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held remote controls. However, the door will
open and close from the Door Control, the Outside Keylock and the Keyless Entry Accessories.
To activate, press and hold the Lock button (3) for 2 seconds. The push bar light will flash as long as
the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds. The push bar light will stop flashing.
The Lock feature will also turn off whenever the “LEARN” button on the opener panel is activated.
25
4
1
2
3
L
i
f
t
M
a
s
t
e
r
2
3
1
1
3
2
60 s
120 s
180 s
O
–
L
i
f
t
M
a
s
t
e
r
L
i
f
t
M
a
s
t
e
r
ADJUSTMENT SECTION
26
11
LOCK
LIGHT
optional