Specification

15
Troubleshooting
Potential Problems Common Solutions
Fan blades don't rotate
Check fuses and/or circuit breakers and reset if needed.
Cut o󰀨 power to the fan and check its internal electrical connections.
Replace the remote control’s batteries.
Check that the fan cover is correctly placed and no fasteners
interfere with the movement of the blades.
Contact customer service to replace a faulty remote control.
Fan is too noisy
Check that all fasteners are well tightened.
Ensure the canopy housing has a short distance between itself
and the ceiling.
Upon initial installation, allow 24 hours of use for the machine to
break itself in.
Cut o󰀨 power to the fan and check that the wire nut connections
are not rubbing against one another or the inner housing.
If you have installed a solid-state variable-speed control, cut o󰀨
power to the fan and disconnect this control from the device. See
if using the remote resolves the problem, which can be caused by
erratic signals from such controls.
Fan wobbles during use
Check that all fasteners are well tightened.
Use the provided blade balancing kit to adjust the blades if their
tips are found to be an unequal distance from the ceiling while
well fastened.
Exchange the position of the various blades.
The receiver beeps during
the adjustment of the LED
light’s brightness or color
temperature
When the light is at its highest brightness or coolest color
temperature, the receiver will beep if you further increase either
value. When the light is at its lowest brightness or warmest color
temperature, the receiver will beep if you further decrease either
value. Stop such further adjustments and the beep will cease.
This is normal and needs no repair.
Contact customer service or a trained technician for inspection,
repair, or replacement of any problematic part.
Again, do not bend the blades during any of these procedures.