Instructions / Assembly

V20240715
1. Prepare the wiring and a junction box
(not included)
in your ceiling for
the desired location of your new lamp.
2. Unscrew the canopy nuts
(M)
from the canopy bolts
(J)
.
3. Take the mounting bracket
(I)
o󰀨 the canopy
(L)
.
4. Connect the mounting bracket to your junction box using the mounting
bolts
(K)
.
If necessary, use the plastic anchors
(A)
and mounting screws
(B)
for
more suitable and secure xation.
5. Pass the wires from the top of the shade
(F)
through the poles
(E)
,
spiral joint
(D)
, and canopy, connecting them to each other as shown.
Use one to ve poles to t the height of your ceiling as needed.
6. Make electrical connections using the wire nuts
(C)
.
For best results, follow
Step 8
to install a bulb and then restore power,
testing that the bulb lights up.
7. Being careful that no wiring is left exposed, place the canopy against
the mounting bracket and secure it by replacing the canopy nuts onto
the canopy bolts.
8. Install your bulbs into the sockets on the lamp holder assembly
(N)
inside the shade.
This xture has been rated for three
E26
bulbs
(not included)
up to
60
watts
each.
9. Bend the di󰀨user
(G)
as shown.
10. Fit the di󰀨user into the shade, starting with one half and then feeding
the other.
11. Pull down the tab
(H)
until the di󰀨user rmly sits on the shade’s inner roll
rim.
12. Restore your power and enjoy!
Installation Instructions
Read these instructions carefully prior to installation.
• Check for electric, gas, and plumbing lines before drilling or consult a professional.
•
ALWAYS
cut
ALL
relevant power
BEFORE
installing a lighting xture.
Put on insulated gloves
BEFORE
restoring power to the line for any tests.
•
DO NOT
mix up the live (black), neutral (white), and ground (green or bare copper) wires.
Seek professional assistance from certied electricians if needed.
• Ask one or more persons for help as needed, particularly in
steps 5–11
.
•
DO NOT
install on uneven or damaged ceilings.
•
DO NOT
install on overhead slopes that exceed an angle of
25
°.
•
DO NOT
use with bulbs exceeding the recommended wattage.
×2
Junction Box
I
C
A
B
D
E
J
K
L
M
F
G
H
N
Bulb