Merry Electronics (Taichung) Co., Ltd. Use Manual WLB902 with SW rev.
Table of Contents 0. REVISION HISTORY ............................................................................................................................ 3 1. USER INTERFACE INTRODUCTION .................................................................................................. 4 2. TURNING ON AND OFF THE HEADSET ............................................................................................ 5 3. PAIRING THE HEADSET (PAIRING MODE) .........................................
0. Revision History Date July 20, 2010 Dec 30, 2010 Mar 18, 2011 Revision V1.00 V1.01 V1.02 Author Joseph Chang Joey Wu Joey Wu Reason for the Change Original Release.
1. User interface introduction Speaker Out Red/Blue LED Volume Up Prev.
2. Turning on and off the headset Press and Hold to Turn on/off Headset To turn on the headset 1. Press POWER key about 2.5 seconds. 2. Release the power key after the blue LED start to flash. 3. The headset will enter paring mode automatically when you turn it on at the first time. If the headset has been paired with any equipment, it will automatically search and link the equipments have been paired. To turn off the headset 1. Press POWER key about 2.5 seconds. 2.
3. After reboot the headset, the headset will try to re-connect the latest device it has been connected. But if they disconnected when the headset is using, please press play key to reconnect the device you just use. 4. The product was submitted and tested for use at the manufacturer’s recommended ambient temperature (Tmra) of 0℃-45℃. 6. LED sequences: LED flash indication Headset status Blue LED show 2.
8. Detail key function: Key Press Product state OFF Power Short - Long On Idle w/o conn. Reconnect to last used device Off Very Long - Pairing Mode Idle with conn.
FCC Regulations: zThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. zThis device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
IC statement Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
