Service manual

Page 5 Mealstream Ovens 32Z3387 Issue 2
Installation Instructions for Mealstream Combination Ovens
Power Supply Requirements
The
Mealstream Series
should be connected to a suitable electricity supply, which can cope
with the switching-on surge that occurs with certain types of catering equipment, such as
microwaves. Because of this requirement, we strongly recommend that a separate, suitably
rated supply is installed for the oven.
The supply for the oven should be fitted with a
Type "C"
circuit breaker, rated at:
30 Amp for Mealstream (all models)
If the oven is hard-wired to the supply, a double-pole isolator switch with a contact gap of at
least 3 mm should be fitted.
Positioning the Oven
In order to maintain adequate ventilation for air intake and exhaust, and to allow access for
cleaning filters, you must allow a minimum of 50 mm clearance at the sides and rear of the
oven, and at least 50 mm above. Air intake temperature should not exceed 35°C - excessive
temperature will lead to reduced operating duty cycle or premature ageing of internal
components.
Failure to comply with these conditions will invalidate the warranty.
NEVER
Install an oven above fryers, grills, griddles or any other major heat source.
NEVER
Stack machines on top of each other - always use a double stand.
ALWAYS
Place containers in the cavity carefully - impact damage may chip the
vitreous enamel coating on the runners and baffle plate.
INSTALLATION INSTRUCTIONS
50mm 50mm
50mm
50mm
350mm