User manual

17
How to put the ARGUS into operation
ARGUS displays and operating elements:
Figure ;:
A To set the sensitivity
B To set the brightness threshold
C To set the switching duration
D Functional display: lights up whenever movement is detected
E Brightness sensor: must not be covered
F1 Range of the front 100° sector (side adjusters F2 and F3 see Figure
_)
Setting the ARGUS for the function test:
1 Set the brightness threshold (Figure ;B) to daytime operation (sun
symbol/right-hand stop).
2 Set the switching duration (Figure ;C) to 1 s (left-hand stop).
3 Set range adjusters F1, F2 and F3 to "max" ("max" at the top, "min" at
the bottom).
Aligning the ARGUS:
1 Figure :: Align the sensor head with the area to be monitored
(change the direction of rotation when you have turned it as far as the
stop).
2 Step from the edge of the detection area into it (Figure §) to check
whether the ARGUS switches the load and the functional display as
required.
Set the range of the 100° sectors:
Using the adjusters F1, F2 and F3 (Figure _) you can reduce the range
of each sector from 100% ("max" at bottom) to 60% ("min" at bottom).
1 Set the range.
18
How to put the ARGUS into operation
Setting the sensitivity:
Here (Figure ;A) you can set the distance up to which ARGUS detects
movements (can be set continuously up to a maximum of 16 m).
1 Set the sensitivity (Figure •).
Setting the brightness threshold:
Here (Figure ;B) you can continuously adjust the ambient brightness
level at which movements should be detected and switching triggered.
1 Set the brightness threshold (Figure
]):
– Right stop (sun symbol): Day and night operation (approx. 1000 lux),
all movements in the area of detection will be detected, independent
of the external brightness.
– Left stop (moon symbol): Night operation (polar white: approx. 3 lux,
dark brazil: approx. 5 lux), movements are only detected in the dark.
Setting the switching duration:
Here (Figure ;C) you can set how long the loads connected to the
ARGUS remain switched on. When the ARGUS detects a movement, the
load is switched on and stays switched on until the set period has
elapsed. Every further movement restarts the switching duration.
|
Note: The ARGUS ignores the light-sensitive switch after the load
has been switched on. If the movement detector does not switch
off again, the reason is probably that the ARGUS has detected
further movements and has restarted the switching duration
several times.
1 Setting the switching duration (Figure
}):
– Left stop: switching duration approx. 1 s
– Right stop: switching duration approx. 8 min