User manual

11
Technische Daten
12
What you can do with the ARGUS 300
The ARGUS 300 is an electronic movement detector for inside and
outside use. It registers moving sources of heat, such as people, within
a defined range (Figure !):
A Inner security zone:
area of detection 360°, radius approx. 4 m.
B Middle security zone:
angle of detection 300°, radius approx. 7 m.
C Outer security zone:
angle of detection 300°, area of detection approx. 16 m x 20 m.
|
Note: The specified ranges refer to average conditions and a
mounting height of 2.5 m and should therefore be taken as guide
values. The range can vary greatly depending on the weather.
The central and the outer security zones are divided into three 100°
sectors, the range of which you can set separately.
The ARGUS 300 switches connected loads whenever it detects a
movement. These could be ohmic loads (e.g. 230 V incandescent and
halogen lamps), capacitive loads (e.g. electronic transformers) or
inductive loads (e.g. low-voltage halogen lamps with inductive
transformer).
The ARGUS 300 is designed for wall mounting on a corner. By removing
and rotating the wall connection box, you can mount the ARGUS 300 to
the left or to the right of a corner (Figure %). With the extension (554395/
554399) you can extend the area of detection of the ARGUS 300 – for
example, to "see past" external drain pipes (Figure &).
|
Note:The ARGUS 300 is not suitable for use as a component of an
alarm system since it is supplied from the mains and will switch the
connected alarm whenever the mains supply fails and recovers,
regardless of whether or not a movement is detected (false alarm).
What you can do with the ARGUS 300