User's Manual

Installing the AP110

The AP110 is designed to be mounted on either a horizontal flat surface (such as a desktop or table) or a

vertical surface (such as a wall). Note that if you are wall-mounting the AP, you will need to purchase two

screws separately. Simply screw them into the wall placed slightly more than three inches apart (use the

image below as a guide when drilling the holes) and slide the AP into place on them.

Figure 1: AP110 Mounting Holes

For horizontal surface deployments, simply place the AP on the desired surface and follow the instructions

below.

Connect and Activate the AP

Refer to Figure 2 as a guide for connections.

1. Connect the port labeled F1 (WAN Port in

Figure 2) to your existing router or internet connection. (The

port should be colored green to distinguish it from the LAN Port.)

2. If necessary, connect another corporate device (such as a VoIP phone) to the port labeled F2 (LAN Port in

Figure 2). Note that this port can be used for any devices that need to be connected to the corporate

network; it acts just as a network port at the office would. (The port should be colored yellow to

distinguish it from the WAN Port.)

3. Connect the supplied power adapter to the 12V DC port on the AP and plug the other end into a power

source. (For Japan customers, use USA power plug SYS1357-USA provided in the box.)

4. Press the On/Off switch to activate the AP110. (The AP is On when the switch is recessed and Off when

extended.) The connection indicator lights at the top of each network port should turn on when the AP is

activated.

5. Connect your wireless station to the wireless network (the SSID is the same as the corporate SSID

configured at your office).

Note:

Be sure to mount the AP in such a manner that the Meru Networks logo on

the top of it is right-side up in order to ensure that the AP is properly

secured. In this configuration, the ethernet ports will be facing upwards.

80mm (3.15 inches)