User's Manual

Where to Go From Here
© 2011 Meru Networks, Inc. Installing AP110 3
Figure 2: AP110 Ports
For technical support, contact your organization’s IT department.
Where to Go From Here
Now that the AP110 is installed, go to the Meru System Director Getting Started Guide for instructions
on initializing the hardware. Return to this chapter to check the status of the LEDs once the WLAN is
operational; note that LED status is configurable, so the chart above may not apply to APs whose status
was reconfigured.
Warning!
The Reset button on the AP110 will erase all configured settings on the
device, including network communications set up by your IT department.
Do not press it unless specifically instructed to do so.
Note:
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
LAN Port (Yellow)
WAN Port (Green)
Power Button
Power Adapter (12V)