User's Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- About This Guide
- About Meru Access Points
- Installing the AP100
- Installing the AP200
- Specifications
- Declarations of Conformity and Regulatory Information
- Translated Safety Warnings
- Channels
Checking LED Activity
Installing the AP100 15
AP100 Status LEDs
Four status LEDs on the face of the AP100 also light, as shown in Figure 11.
.
Figure 11: Access Point 100 Status LEDs
The Power LED, nearest to the Meru logo, displays green when power is on.
The functions of the LEDs are described in Table 3.
Table 3: AP100 LED Descriptions
When the AP is first connected to the controller and any time the access point is rebooted thereafter,
the AP initializes with and then is programmed by the controller. LED 2 gives the status of the boot
cycle. Table 4 lists typical successful boot information.
LED Function
LED1 Green: Presence of power
LED2 Boot status (see Table 4)
LED3 Green: Wireless transmit activity (TX)
LED4 Green: Wireless receive activity (RX)
Power
Boot status
Wireless TX
Wireless RX
00136